DIY - Trailer WIre Kit installation 2009 Toyota Rav4

This is for a 2009 Toyota Rav4 Trailer Installation Kit .

Part #118412

Removing all the carpets and trunk area to freely install the wire kit - Then you start with the back of the plastic protector 

Removing the bolts and screws on the side panel then gently pull away from the vehicle - This way when you wire up you can cross the brake light wires from left to right 

On each side you can add the center connector - Remove the plug then re plug into the by pass wires 

As you make sure that the box is on the driver side of the vehicle - Tuck and hide your wires then you will see a rubber plug and slice a hole it in to that when you wire up to the battery that will be your access hole . 

Ground your wires and crimp the main wire then start sliding all your wiring in the hole that you removed the plugged from 

Now travel down the driver side of the frame and tie strap the wire making it safe from falling or rubbing on anything - Take your time 

Then with the fuse you need to cut it in the middle again hide wire - crimp your hook then connect it to the positive side of the battery 

Once you have everything wired up and secured then you can put everything back - Use Dielectric Grease for your plug - Wrap it up securely so it doesn't rub then test wire to trailer . 

More DIY @ www.corollacarclub.proboards.com 

.