DIY - 2000 Infiniti I30 Front & Rear Motor Mounts Replacement

This is a DIY for a 2000 Infiniti I30 front and rear ELECTRONIC motor mounts .

Get the vehicle as high as you can and use jack stands . I never done this on this type of vehicle so I put two jack on each end of the motor so it doesn't drop because I will be removing the whole middle sub frame .

This is really easy and the access to the top center bolts are easy to get to . Once you remove the top center bolt on the front and rear mount . 

Make sure you unplug the motor mounts in this photo I already had my air filter box off because the rear mount wire runs under the starter and yes there are clips along the route .

The front one is easy all you have to do is unplug it from the top .

Now you remove the three bolts in the front of the sub frame then the two in the rear of the sub frame but be careful this will drop .

Now on this vehicle it has electronic motor mounts that if you do not put the same you will have vibration in the motor and your service engine soon light will be on . There is a reason for this wires .

Make sure wires face out driver side . In my case I cleaned the oil from the sub frame . 

When you put it back you can put the mounts on the center first then raise the sub frame then bolt to sub frame or if you keep the mounts on the frame put the center bolts first then bolt in the sub frame . Either way is fine . 

Once you are finished plug in the motor mounts .

This is the easiest motor mount replacement . Other then that wire under the starter and removing the air filter box that is all .

.

DIY Rear Motor Mount 2000 Honda CRV

 This is a DIY on a rear motor mount for a 2000 Honda CRV 

 Its easier to remove the air intake on this DIY but you can do it with it on it 

Three bolts on the bottom and one in the center but I took it upon myself to remove the bracket since I had the car all opened up 

To remove the bracket you have two bolts on the top and one on the bottom

Once you are done then you just install it the same way you took it off 

More DIY www.COROLLACARCLUB.proboards.com 

,

DIY 93-97 Rear Motor Mount Replacement

 

This is a DIY for the rear motor mount .

 

 

For this DIY you need to raise your corolla real high so that you have room to work underneath it . You do not need anything to hold the engine up . 

 

First remove the muffler pipe bracket . Then you remove the center bolt of the rear mount .



Then you can remove the bolts to the rear motor mount and remove the bolts for the sub frame but DO NOT REMOVE THE SWAY BAR LINKS OR BALL JOINTS

The purpose of removing the sub frame bolts is so that you can pull it down and remove the rear motor mount while the sub frame is still hanging .

 

 

 

 

Then once you remove the rear motor mount you go in reverse to put it back on . But you can start by putting the center bolt then push up on the sub frame and put all the bolts back .

 

 

 

For more info www.corollacarclub.proboards.com

 

 

 

 

 

.