DIY - Trailer WIre Kit installation 2009 Toyota Rav4

This is for a 2009 Toyota Rav4 Trailer Installation Kit .

Part #118412

Removing all the carpets and trunk area to freely install the wire kit - Then you start with the back of the plastic protector 

Removing the bolts and screws on the side panel then gently pull away from the vehicle - This way when you wire up you can cross the brake light wires from left to right 

On each side you can add the center connector - Remove the plug then re plug into the by pass wires 

As you make sure that the box is on the driver side of the vehicle - Tuck and hide your wires then you will see a rubber plug and slice a hole it in to that when you wire up to the battery that will be your access hole . 

Ground your wires and crimp the main wire then start sliding all your wiring in the hole that you removed the plugged from 

Now travel down the driver side of the frame and tie strap the wire making it safe from falling or rubbing on anything - Take your time 

Then with the fuse you need to cut it in the middle again hide wire - crimp your hook then connect it to the positive side of the battery 

Once you have everything wired up and secured then you can put everything back - Use Dielectric Grease for your plug - Wrap it up securely so it doesn't rub then test wire to trailer . 

More DIY @ www.corollacarclub.proboards.com 

.

DIY Removing Front Spoiler Fog Light Assembly on a 03 - 08 Corolla S

This is a DIY on how to remove the fog light assembly on a 03 - 08 Corolla S model vehicle with the body kit .

Part Number for a New Driver side Fog Light OEM # 81220-AA011

Once you remove the front of the fender liner bolt then you come to the back of the front bumper spoiler and remove that screw .

Now under the car behind the bumper cover you will see c lips that hold the front spoiler , Just remove them pull lip forward then pull fog light assembly out .

There you have it then put the new assembly and reverse the process.

.

DIY Replacing Passenger Rear Door Handle on a 03 - 08 Corolla

This is DIY for a 03 - 08 Corolla . 

I got the handle according to the color of the vehicle from the dealership .

Part Number # 69211-AA020-B1

Remove the hidden screw behind the inside handle - Then pull up the arm wrest and you will see two more screws then unplug the window switch .

Pull the panel away then where the latch assembly is remove the three screws gently push down the latch assembly making room to put tool through.

With a torx screw driver loosen the screw where the cap is held on then you can gently remove the cap with out making the screw fall out then slide in handle then reverse the process .

There you have it simple .

.