DIY Replacing Clip Rivet Retainer Fasteners for a Corolla

This is clips for a Corolla but it can be universal for any type of vehicle .

But splash guards purpose is to keep water from splashing on your motor and other parts especially your a/c from rusting and going out . Some people cam care less but this is highly important and if you have a show car even better to keep it clean from snow , mud or water .

Real simple to clip in , Just find the fastener that fits your needs . 

For this I used Clip Rivet Retainer Fastener 18/7.5/7mm; 0.71/0.3/0.28 inch

.

DIY Replacing Driver Side Fender Liner 03 - 08 Corolla

This is a DIY for a 03 - 08 Corolla driver side fender liner .

The importance of this is to keep water out as you hit puddles or when it rains from ruining your fog lights and if you live in a area that snows a lot keeps snow from piling up inside your fender .

                                    

These are the clips I purchased on ebay .

18/7.57/mm: 0.71/0.3/0.28 inch

Clip Rivet Retainer Fastener 

Part Number for Driver Side Fender Liner Toyota OEM #538760 - 2090 . 

Locating all the wholes for the retainer clips make sure you clip them all . Easier if you take the tire off but if you are flexible then keep tire on . 

.

DIY - Corolla Fender Liner 98 - 02

 This is a DIY for a Corolla fender liner . A reminder that a Corolla 98 - 99 are different from a 00 - 02 so before you order make sure you have purchased the correct one .

All you would need is a flat head screw driver and a ratchet 10mm . This DIY takes about 5 minutes with out taking the tire off all you need to do is raise the car up till the tire comes off the ground a little .

As you can see in the photo above my old one was broken .

 The purpose of the fender liner is to keep rocks , salt , snow, water to ruin the wires under the fender or in my case to protect my HID box .

With the ratchet you remove the 3 bolts one is by the tow hook in the front and the others are spread center and back , then with your flat head you pop out the other push fasteners , If necessary you can purchase the push fasteners at Auto Zone just make sure you have the correct size sometimes these will break of you would need a pliers to help you pull them out .

Once you remove the liner then you do it in reverse and make sure the liner is nice and tight .

These photos about is the new fender liner and how it should look when it is all done .

More DIY at : http://www.corollacarlcub.proboards.com/