This is a DIY on the right side transmission mount on a 1.8 automatic Corolla .
Raise the car slightly then place another floor jack under the transmission raising it till you see it touch the engine . This is to keep the motor from tilting .
Remove the air intake box and then you can remove the bolts from on top .
Where my finger is pointing you have to go under the car and remove to bolts .
Then you remove the center bolt of the mount .
From this point you remove the bracket from the old mount and the two rubber heat shields and put them on the new mount .
Now when you put the new mount on you might have to raise the motor , In this photo I had to use screw drivers to line up the center bolt because the new rubber in the mounts sat higher .
Put everything back the same way you took it off and there you have it .
For More Info : www.CorollaCarClub.proboards.com
No comments:
Post a Comment