DIY - 2000 Infiniti I30 Driver Side Transmission Mount

This is a DIY for a 2000 Infiniti I30 Driver side Transmission Mount 

With two jacks one holding the vehicle up and the other holding the engine . 

Basically you have to take the air filter box off and the battery tray out to get access to the bolt holding the mount .

In my case I had purchased ebay motor mounts a full set and it seems that this transmission mount I had to do some minor modifications but the other mounts were perfect .

There is a reason why this mount is aluminum because of the height so with quick thinking I found 4 strut mount nuts I had on hand and used them to raise the metal flat base mount .

Once you remove the mount then reverse the process .

Again if you have the correct mount then NO modification needed .

If you happen to get the wrong mount don't panic you can modify .

The most time consuming to do this job is taking the air box and battery out .

.

DIY - Corolla 93 - 97 Replacement Transmission Mount

 

 

 

This is a DIY on the right side transmission mount on a 1.8 automatic Corolla .

 

 

 

Raise the car slightly then place another floor jack under the transmission raising it till you see it touch the engine . This is to keep the motor from tilting .

 

Remove the air intake box and then you can remove the bolts from on top .

 

 

Where my finger is pointing you have to go under the car and remove to bolts .

 

 

Then you remove the center bolt of the mount .

 

 

 

From this point you remove the bracket from the old mount and the two rubber heat shields and put them on the new mount .

 

Now when you put the new mount on you might have to raise the motor , In this photo I had to use screw drivers to line up the center bolt because the new rubber in the mounts sat higher .

                      Put everything  back the same way you took it off and there you have it .

 

For More Info : www.CorollaCarClub.proboards.com