This is a DIY on a 2000 Infiniti I30 removing and replacing a outer tie rod end .
Remove the cotter pin from the bottom
Then you can remove the castle nut
Then with a outer tie rod tool you can pop off the part from the spindle
Remember to count or mark where the old outer tie rod end was so that you can get it as close as you can before you get a alignment
Loosen the locking nut then remove the outer tie rod
Once you are done with the steps the you can put everything back and head to your local alignment shop and get it adjusted correctly
If you don't get it aligned you will eat your tires
More DIY @ www.corollacarclub.proboards.com
.
No comments:
Post a Comment