Wednesday, October 14, 2015

DIY - Serpentine Belt 2000 Honda CRV

This DIY is on a 2000 Honda CRV with a 2.4 Motor - The Diagram below is correct route for the serpentine 




Remove the cover below that covers the a/c and crankshaft - As you see in the second photo that is where the location of the belt tensioner - All you have to do is unclasp the power steering canister and move it aside 





With my homemade serpentine belt tool you pull the tensioner forward and you will see the belt getting loose - From that point you un slip the top part of the belt 





Once you have the serpentine belt off the top you can pull it from the bottom - Make sure you measure the new one before you put it on - Check tensioner pulley to make sure it still has tension - Remember the route of the belt if not this page provides a diagram 





Then you put the new belt on the same way you took it off - Make sure the grooves are matching and laying flat - Feel the tension - Then put the cover and power steering pump canister back 






More DIY @ www.COROLLACARCLUB.proboards.com









.


No comments:

Post a Comment