DIY Replacing Harmonic Balancer 2000 Infiniti I30

This is a DIY on how to replace a harmonic balancer on a 2000 Infiniti I30 

First thing you must do is to remove the belts - You have the belt adjuster to the right that tightens the alternator and air condition - Then to your left you have the power steering pump that needs to be loosen as well - Once you have the belts off then you can continue

With a impact wrench you remove the middle bolt then with a pulley gently remove the harmonic balancer 

Make sure after you remove the harmonic balancer check to make sure the key is still in place and there is no scratches or burrs on the shaft - Then you can replace the timing cover shaft seal 

Make sure the two balancer are equal - Gently slide the balancer where the key will slide through the balancer with our force 

Then with a impact you can tighten the harmonic balancer - then you can put the belt back on and check for leaks 

This is the best time to replace both belts and any other parts that look worn out especially on a car with over 100.000 miles on it whether leaking or not replace now then later 

More DIY at www.corollacarclub.proboards.com 

.

DIY Replacing A/C & Alternator Belt Adjuster 2000 Infiniti I30

 This is a DIY on a 2000 Infiniti I30 on how to replace a alternator and a/c belt tensioner

First thing you do is to loosen up the belt from the top where the adjusting screw is located 

Once the belt is loose then you can remove the belt then take the pulley off - from there you remove the three bolts holding the bracket 

This is what it looks like apart - you must use the old brace for the tensioner 

This is what it looks like before you install the belt tensioner back 

You have to put this back first before you put the pulley wheel 

Then adjust the belt with a new belt 

Make sure the belt is properly tight so you can avoid squeaking - this belt is in the front of the power steering belt - might be a good time to change both 

More DIY at www.corollacarclub.proboards.com

.

DIY - Serpentine Belt 2000 Honda CRV

This DIY is on a 2000 Honda CRV with a 2.4 Motor - The Diagram below is correct route for the serpentine 

Remove the cover below that covers the a/c and crankshaft - As you see in the second photo that is where the location of the belt tensioner - All you have to do is unclasp the power steering canister and move it aside 

With my homemade serpentine belt tool you pull the tensioner forward and you will see the belt getting loose - From that point you un slip the top part of the belt 

Once you have the serpentine belt off the top you can pull it from the bottom - Make sure you measure the new one before you put it on - Check tensioner pulley to make sure it still has tension - Remember the route of the belt if not this page provides a diagram 

Then you put the new belt on the same way you took it off - Make sure the grooves are matching and laying flat - Feel the tension - Then put the cover and power steering pump canister back 

More DIY @ www.COROLLACARCLUB.proboards.com

.