Wednesday, August 6, 2014

DIY - Quick Release Bumper Clips

                                      

    This is a easy DIY for your front bumper to quick release it when you are to low to be towed or to get over speed bumps , Even if you want to take it off so you wont get bugs on it before a show you can drive with no bumper then instal it on real quick . This DIY even makes it easier to work on your car when need to remove the front bumper . 


This kit is real simple and comes with screws and nuts . Easiest way i did it was to remove the bumper ,






You mainly measure and drill a whole so that you can stretch the rubber ring around the hooks and so that when they are hooked it will pull up on the bumper to stay fit with the fender and wont rattle . 





Once you are complete you can twist it or you can leave it open in the center . Make sure you put the two top bolts to hold the top and the quick release clips to hold the nose and side to the fender .


More DIY www.corollacarclub.proboards,com 




.

No comments:

Post a Comment