DIY Replace Rear Brakes and Rotors 2000 Honda CRV

This is a DIY for a 2000 Honda CRV rear brakes conversion to slotted rotors 

First you remove the rear brake caliper then you remove the brake caliper bracket 

With a screw driver you remove the two screws holding the rotor to the shaft 

Inspect and clean emergency brake shows that are located inside the rotor 

Replace all the hardware that is supplied - make sure slotted rotors are facing the correct direction - put everything back the same way you removed the old parts 

More DIY @ www.COROLLACARCLUB.proboards.com 

.

DIY Replace Radiator Over Flow Tank 2000 Toyota Camry

This is a DIY on how to replace your coolant over flow tank on a 2000 Toyota Camry 

In this DIY I'm using the OEM part - There are two bolts holding this to the inside of the fender 

Make sure you use the bracket from the old over flow tank and then you put it back the same way you took it off - fill with coolant and your back to normal 

More DIY @ www.COROLLACARCLUB.proboards.com 

.

DIY Replace Front Brakes 2011 Hyundai Sonata

This is a DIY for a 2011 Hyundai Sonata front brake replacement 

Two bolts hold these front pads , Once you remove these bolts then you can slide the brake caliper off the rotor - Make sure you replace all the hardware when putting your new pads 

To push the front caliper back you must either use the proper brake tool but in this case you can use a C - clamp cause you have to go in on a angle to push the piston back - be careful cause these calipers are made of aluminum 

Once you have everything off you put it on the same way - 

More DIY @ www.COROLLACARCLUB.proboards.com

.