DIY Replace Front Brakes 2011 Hyundai Sonata

This is a DIY for a 2011 Hyundai Sonata front brake replacement 

Two bolts hold these front pads , Once you remove these bolts then you can slide the brake caliper off the rotor - Make sure you replace all the hardware when putting your new pads 

To push the front caliper back you must either use the proper brake tool but in this case you can use a C - clamp cause you have to go in on a angle to push the piston back - be careful cause these calipers are made of aluminum 

Once you have everything off you put it on the same way - 

More DIY @ www.COROLLACARCLUB.proboards.com

.

DIY - Front Brakes & Rotors 2000 Honda CRV

This is a DIY for a 2000 Honda CRV Front Brakes with Slotted Rotors

To remove the calipers you need to unscrew the top and bottom bolt - Then you will see a tension spring that if you did not purchase the hardware kit you will be using these again - The reason it is called a tension spring cause this is what pushes your front pads back as the caliper opens - These are important to reinstall 

Then with a 17mm socket you remove the caliper bracket so that you can remove the front rotor 

On this vehicle you have two screws holding the rotors to the hub 

Make sure you have the lines facing forward or read the sticker driver side and passenger side face different ways 

Only on the bolts you need to apply anti seize 

This vehicle takes ceramic pads 

With the caliper tool push the calipers back then starting putting everything on the same way you took it off 

When putting the caliper back on you will have to squeeze the pads to the rotors because the spring tensioner will push the pads out until the caliper surrounds the pads - What I did was slip the bottom of the caliper first then leave a opening to put the spring tensioner for the top then slide the rest of the caliper 

There you have it 

More DIY @ www.COROLLACARCLUB.proboards.com 

.

DIY - Front Brake and Rotors 2000 Toyota Camry

This is a DIY for front brakes and rotors for a 2000 Toyota Camry

 

 

First you remove the top and bottom bolt that holds the brake caliper to the bracket - Once you have taken the caliper off then you remove the front pads - If needed help use a flat head screw driver - Once you have the pads off remove the two bolts holding the caliper bracket to the spindle - From there you can remove the rotor

 

Make sure you inspect the new rotors to the old ones - In this year Camry there is a difference between a 14 inch rim and a 15 inch rim - Rotors do come in two different sizes - If you are using slotted rotors make sure they are facing the correct direction

 



 

Then with a brake caliper tool push the caliper back

 

 

 

Once you are done then you can replace everything back the same way you took it off

 

 

More DIY @ www.CorollaCarClub.proboards.com

 

 

 

 

 

 

 

.