DIY - Replacing Upper & Lower Radiator Hose 2005 Corolla

This DIY is for a 2005 Corolla .

First you have to drain the radiator in a safe manor .

Then you flush out the over flow tank so that you do not mix fluids plus keep all fluids new and not to contaminate the newer fluid . 

With pliers you can easily remove the clamps to the upper and lower hose . 

Make sure you replace the clamps and to grease the inner part of the hoses so if you ever need to go back there it will not stick and be easily to remove . 

Match up the hoses .

Make sure you burp the system and check the clamps .

More DIY at www.corollacarclub.proboards,com

.

DIY Radiator & Hoses Replacement 2000 Infiniti I30

This is a DIY for a Infiniti I30 replacing the radiator and the hoses 

Drain your coolant 

Remove all the hoses and disconnect the wires coming off the radiator fans so that you can remove the fan assembly  

If you have a automatic carefully remove the lines going to the radiator then you can remove the radiator after taking off the hold down brackets 

Flush block and clean outside if motor while everything is off 

Make sure you have all your parts - Now is a good time ever to replace your hoses or thermostat if needed but in this case it wasn't 

Clean all areas that the hoses clamp onto 

Replace the rubber grommets that keeps the radiator from vibrating 

Lube inside of the hose for future work it makes it easier to take them off 

There is a bleeder valve hidden where the top hose goes into - Make sure you remove the bolt while filling up NOT when engine is running or else it will spray hot coolant all over - Once coolant comes out with no air then you can bolt it down - Run car turn on heat make sure everything is not leaking and in a weeks worth of time check hose clamps again 

More info www.COROLLACARCLUB.PROBOARDS.com

.

DIY Replace Coolant Reservoir Tank 2000 Infinit I30

This is a DIY on a 2000 Infiniti I30 Coolant Reservoir Tank or also known as the Over flow tank .

On this vehicle you have two bolts holding the reservoir .

Make sure you match them up 

Connect the new hose to the radiator by the cap . Then refill to the line .

More DIY at www.corollacarclub.proboards.com 

.

DIY Replace Radiator Over Flow Tank 2000 Toyota Camry

This is a DIY on how to replace your coolant over flow tank on a 2000 Toyota Camry 

In this DIY I'm using the OEM part - There are two bolts holding this to the inside of the fender 

Make sure you use the bracket from the old over flow tank and then you put it back the same way you took it off - fill with coolant and your back to normal 

More DIY @ www.COROLLACARCLUB.proboards.com 

.

DIY Replacing A/C Condenser Fan Honda CRV 2000

This is a DIY on a 2000 Honda CRV - First you remove all the clips on top of the radiator so that the shield can be taking off to see the fan .

 

Once you remove the plastic shield you will take off the two nuts holding the fan that is to the LEFT of the radiator - The RIGHT side is for the temperature switch . Then you remove the reservoir for the antifreeze .

 

 

 

There is a bracket that holds the radiator down remove those on each side on the top , Then you remove the bracket that is holding the grill and the plastic bumper off to - This way you can lean the radiator forward and pull out the fan

 

 

On the bottom you remove the clips that hold the water shield to the vehicle - You need to remove the little drain hose from the bracket of the condenser fan and a plug that is clipped to the bracket .

 

Once everything is loosen then you pull the radiator forward carefully and remove the fan from the top .

 

 

Then once you remove the fan you follow the steps in reverse to put the new fan back - You might have to purchase new clips cause when they are old they break - There is about 25 or more clips better to purchase them from eBay where they are cheaper .

 

 

 

More DIY at www.corollacarclub.proboards.com

 

 

 

 

 

 

 

 

 

 

.